V-Cone and NX-19 technical documents are maintained by McCrometer and NIST respectively. The AGA-3, AGA-7, AGA-11 and AGA-8 industrial standard thermodynamic models is governed by American Gas Association (AGA), and documents for these models can be purchased though AGA.
NX-19 for gas compressibility calculation in legacy applications Realflo can also be used to configure and calibrate the SCADAPack 4000, 42, as well as Rosemount MVT transmitters. AGA-8 Detailed calculation for gas compressibility calculation. V-Cone for gas volume calculation with V-Cone gas flow meters. AGA-11 for gas volume calculations with Coriolis meters (this calculation type is not supported on 16-bit controllers). AGA-7 for gas volume calculation with turbine meters. AGA-3 (1992) for gas volume calculation with orifice meters. The industrial standard thermodynamic models that is encapsulated on Realflo are as follows. This turnkey software solution is used in oil and gas applications. Realflo is software loaded onto a Schneider Electric SCADAPack, that performs gas and/or liquid flowrate calculation using thermodynamic model. 68 IMPLEMENTING SUBROUTINES IN TELEPACE.Learn how to activate RealFlo license using Telepace Studio. 57 STEP 4 CHANGE SET POINTS TO REGISTERS FROM CONSTANTS. 55 STEP 2 MULTIPLY INPUT REGISTER BY 100. 55 STEP 1 SUBTRACT INPUT REGISTER BY 6553 – 4MA = 0. 54 Representing Numbers in the Controller. 51 ADDING HYSTERESIS TO THE PUMP CONTROL. 50 ANALOG INPUT TO START AND STOP THE PUMP. 49 STEP 1 STEP 2 STEP 3 STEP 4 STEP 5 CREATE TAG NAMES. 30 WRITE LADDER LOGIC PROGRAM TO THE CONTROLLER. 26 CREATE AND COMMENT LADDER LOGIC PROGRAM. 
25 ADD CONFIGURATION AND DIAGNOSTIC I/O MODULES. 25 CONFIGURE 5000 SERIES I/O MODULES USED IN THE APPLICATION. 24 CONFIGURE CONTROLLER REGISTER ASSIGNMENT. 24 CONFIGURE CONTROLLER SERIAL PORT SETTINGS. 23 CONFIGURE CONTROLLER FOR SERVICE MODE. 23 INSTALL SERIAL CONNECTION BETWEEN PC AND CONTROLLER. All other product names are copyright and registered trademarks or trade names of their respective owners.ĬONTROL MICROSYSTEMS SCADA products. Trademarks TeleSAFE, TelePACE, TeleBUS, SmartWIRE, SCADAPack, SCADAWave, and SCADARange are registered trademarks of Control Microsystems Inc. TelePACE Studio Ladder Editor Training Manual ©1999-2009 Control Microsystems Inc.
0 kommentar(er)
